R21xx-HP FlexFabric 11900 MPLS Configuration Guide

126
After the configurations, LDP sessions are established between PE 1, P, and PE 2. Execute the
display mpls ldp peer command. The output shows that the session status is Operational. Execute
the display mpls ldp lsp command. The output shows the LSPs established by LDP. Take PE 1 as an
example:
[PE1] display mpls ldp peer
Total number of peers: 1
Peer LDP ID State LAM Role GR MD5 KA Sent/Rcvd
2.2.2.9:0 Operational DU Passive Off Off 5/5
[PE1] display mpls ldp lsp
Status codes: * - stale, L - liberal
Statistics:
FECs: 3 Ingress LSPs: 2 Transit LSPs: 2 Egress LSPs: 1
FEC In/Out Label Nexthop OutInterface
1.1.1.9/32 3/-
-/1151(L)
2.2.2.9/32 -/3 172.1.1.2 Vlan-interface13
1151/3 172.1.1.2 Vlan-interface13
3.3.3.9/32 -/1150 172.1.1.2 Vlan-interface13
1150/1150 172.1.1.2 Vlan-interface13
3. Configure VPN instances on PEs:
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 111:1
[PE1-vpn-instance-vpn1] quit
[PE1] ip vpn-instance vpn2
[PE1-vpn-instance-vpn2] route-distinguisher 100:2
[PE1-vpn-instance-vpn2] vpn-target 222:2
[PE1-vpn-instance-vpn2] quit
[PE1] interface vlan-interface 11
[PE1-Vlan-interface11] ip binding vpn-instance vpn1
[PE1-Vlan-interface11] ip address 10.1.1.2 24
[PE1-Vlan-interface11] quit
[PE1] interface vlan-interface 12
[PE1-Vlan-interface12] ip binding vpn-instance vpn2
[PE1-Vlan-interface12] ip address 10.2.1.2 24
[PE1-Vlan-interface12] quit
# Configure PE 2.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 200:1
[PE2-vpn-instance-vpn1] vpn-target 111:1
[PE2-vpn-instance-vpn1] quit
[PE2] ip vpn-instance vpn2
[PE2-vpn-instance-vpn2] route-distinguisher 200:2
[PE2-vpn-instance-vpn2] vpn-target 222:2
[PE2-vpn-instance-vpn2] quit
[PE2] interface vlan-interface 11