R21xx-HP FlexFabric 11900 MPLS Configuration Guide

132
[PE1] ping -vpn-instance vpn1 10.1.1.1
PING 10.1.1.1 (10.1.1.1): 56 data bytes
56 bytes from 10.1.1.1: icmp_seq=0 ttl=255 time=1.000 ms
56 bytes from 10.1.1.1: icmp_seq=1 ttl=255 time=0.000 ms
56 bytes from 10.1.1.1: icmp_seq=2 ttl=255 time=0.000 ms
56 bytes from 10.1.1.1: icmp_seq=3 ttl=255 time=0.000 ms
56 bytes from 10.1.1.1: icmp_seq=4 ttl=255 time=0.000 ms
--- 10.1.1.1 ping statistics ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/stddev = 0.000/0.200/1.000/0.400 ms
4. Establish EBGP peer relationships between PEs and CEs, and redistribute VPN routes into BGP:
# Configure CE 1.
[CE1] bgp 65410
[CE1-bgp] peer 10.1.1.2 as-number 100
[CE1-bgp] ipv4-family unicast
[CE1-bgp-ipv4] peer 10.1.1.2 enable
[CE1-bgp-ipv4] import-route direct
[CE1-bgp-ipv4] quit
[CE1-bgp] quit
# Configure PE 1.
[PE1] bgp 100
[PE1-bgp] ip vpn-instance vpn1
[PE1-bgp-vpn1] peer 10.1.1.1 as-number 65410
[PE1-bgp-vpn1] ipv4-family unicast
[PE1-bgp-ipv4-vpn1] peer 10.1.1.1 enable
[PE1-bgp-ipv4-vpn1] peer 10.1.1.1 next-hop-local
[PE1-bgp-ipv4-vpn1] import-route direct
[PE1-bgp-ipv4-vpn1] quit
[PE1-bgp-vpn1] quit
[PE1-bgp] quit
# Configure CE 2 and PE 2 in the same way that CE 1 and PE 1 are configured. (Details not
shown.)
After completing the configuration, execute the display bgp peer ipv4 vpn-instance command on
the PEs. The output shows that a BGP peer relationship has been established between a PE and a
CE and has reached the Established state.
Take PE 1 as an example:
[PE1] display bgp peer ipv4 vpn-instance vpn1
BGP local router ID: 1.1.1.9
Local AS number: 100
Total number of peers: 1 Peers in established state: 1
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
10.1.1.1 65410 4 4 0 2 00:00:13 Established
5. Establish an MP-IBGP peer relationship between PEs: