R21xx-HP FlexFabric 11900 MPLS Configuration Guide

229
Ste
p
Command Remarks
6. Configure an MTU for the
cross-connect.
mtu mtu
The default MTU is 1500 bytes.
The two PEs at the ends of an LDP
PW must have the same MTU on
the cross-connect. Otherwise, the
PW cannot go up.
Configuring a PW
Configuring a PW class
You can configure PW attributes such as the PW type in a PW class. PWs with the same attributes can
reference the same PW class.
To configure a PW class:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a PW class and enter
PW class view.
pw-class class-name By default, no PW class is created.
3. (Optional.) Specify the PW
type.
pw-type { ethernet | vlan } By default, the PW type is VLAN.
Configuring a static PW
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect group
view.
xconnect-group group-name N/A
3. Enter cross-connect view.
connection connection-name N/A
4. Configure a static PW and
enter PW view.
peer ip-address pw-id pw-id
in-label label-value out-label
label-value [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
By default, no static PW is
configured.
Configuring an LDP PW
Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information about
MPLS LDP configuration, see "Configuring LDP."
T
o configure an LDP PW:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A