R21xx-HP FlexFabric 11900 MPLS Configuration Guide

264
This chapter describes only VPLS configurations on a PE. For more information about other configurations,
see specific configuration guides.
To configure VPLS on a PE, perform the following tasks:
Tasks at a
g
lance Remarks
(Required.) Enabling L2VPN N/A
(Required.) Configuring an AC N/A
(Required.) Configuring a VSI N/A
Configuring a PW:
• (Optional.) Configuring a PW class
• (Required.) Choose either of the following tasks to configure a PW:
{ Configuring a static PW
{ Configuring an LDP PW
Choose a PW configuration
method depending on the VPLS
implementation.
(Required.) Binding an AC to a VSI N/A
(Optional.) Configuring PE dual homing N/A
(Required.) Configuring MAC address learning N/A
Enabling L2VPN
You must enable L2VPN so the PE can support MPLS L2VPN.
To enable L2VPN:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable L2VPN.
l2vpn enable By default, L2VPN is disabled.
3. Configure an LSR ID for the
PE.
mpls lsr-id lsr-id
By default, no LSR ID is configured.
For more information about this
command, see MPLS Command
Reference.
4. Enter the view of the
backbone interface.
interface interface-type
interface-number
N/A
5. Enable MPLS.
mpls enable
By default, MPLS is disabled on an
interface.
Configuring an AC
An AC is a service instance on a Layer 2 Ethernet interface that connects to a CE.
After you configure a service instance on a Layer 2 Ethernet port, the Layer 2 Ethernet port uses the
service instance to match received packets.
To configure a service instance on a Layer 2 Ethernet interface: