R21xx-HP FlexFabric 11900 MPLS Configuration Guide

273
[PE3-Ten-GigabitEthernet1/0/1-srv10] quit
Verifying the configuration
# Execute the display l2vpn pw verbose command on PE 1. The output shows two static PWs in up state
have been established.
[PE1] display l2vpn pw verbose
VSI Name: svc
Peer: 2.2.2.9 PW ID: 3
Signaling Protocol : Static
Link ID : 8 PW State : Up
In Label : 100 Out Label: 100
MTU : 1500
PW Attributes : Main
Tunnel Group ID : 0x1800000760000005
Tunnel NHLFE IDs : 133
Peer: 3.3.3.9 PW ID: 3
Signaling Protocol : Static
Link ID : 9 PW State : Up
In Label : 200 Out Label: 200
MTU : 1500
PW Attributes : Main
Tunnel Group ID : 0x1800000860000006
Tunnel NHLFE IDs : 135
LDP PW configuration example
Network requirements
Configure VPLS on each PE, and establish LDP PWs between the PEs to interconnect the CEs.
Figure 75 Network diagram
Configuration procedure
1. Configure an IGP and a public tunnel on each PE. (Details not shown.)
2. Configure PE 1: