R21xx-HP FlexFabric 11900 MPLS Configuration Guide

[MCE-vpn-instance-vpn1] route-distinguisher 10:1

[MCE-vpn-instance-vpn1] vpn-target 10:1

[MCE-vpn-instance-vpn1] quit

[MCE] ip vpn-instance vpn2

[MCE-vpn-instance-vpn2] route-distinguisher 20:1

[MCE-vpn-instance-vpn2] vpn-target 20:1

[MCE-vpn-instance-vpn2] quit

# Create VLAN 10, add port Ten-GigabitEthernet 1/0/1 to VLAN 10, and create VLAN-interface

10.

[MCE] vlan 10

[MCE-vlan10] port ten-gigabitethernet 1/0/1

[MCE-vlan10] quit

# Bind VLAN-interface 10 with VPN instance vpn1, and configure an IPv6 address for the VLAN

interface.

[MCE] interface vlan-interface 10

[MCE-Vlan-interface10] ip binding vpn-instance vpn1

[MCE-Vlan-interface10] ipv6 address 2001:1::1 64

[MCE-Vlan-interface10] quit

# Configure VLAN 20, add port Ten-GigabitEthernet 1/0/2 to VLAN 20, bind VLAN-interface 20

with VPN instance vpn2, and assign an IPv6 address to VLAN-interface 20.

[MCE] vlan 20

[MCE-vlan20] port ten-gigabitethernet 1/0/2

[MCE-vlan20] quit

[MCE] interface vlan-interface 20

[MCE-Vlan-interface20] ip binding vpn-instance vpn2

[MCE-Vlan-interface20] ipv6 address 2002:1::1 64

[MCE-Vlan-interface20] quit

# On PE 1, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for each

VPN instance.

<PE1> system-view

[PE1] ip vpn-instance vpn1

[PE1-vpn-instance-vpn1] route-distinguisher 30:1

[PE1-vpn-instance-vpn1] vpn-target 10:1

[PE1-vpn-instance-vpn1] quit

[PE1] ip vpn-instance vpn2

[PE1-vpn-instance-vpn2] route-distinguisher 40:1

[PE1-vpn-instance-vpn2] vpn-target 20:1

[PE1-vpn-instance-vpn2] quit

2. Configure routing between the MCE and VPN sites:

The MCE is connected to VPN 1 directly, and no routing protocol is enabled in VPN 1. Therefore,

you can configure IPv6 static routes.

# On VR 1, assign IP address 2001:1::2/64 to the interface connected to the MCE and

2012:1::2/64 to the interface connected to VPN 1. Add ports to VLANs. (Details not shown.)

# On VR 1, configure a default route, specifying the next hop as 2001:1::1.

<VR1> system-view

[VR1] ipv6 route-static :: 0 2001:1::1