R21xx-HP FlexFabric 11900 Network Management and Monitoring Command Reference

191
Views
System view, interface view
Predefined user roles
network-admin
Parameters
group-id: Specifies the mirroring group ID in the range of 1 to 4. The mirroring group specified by
group-id must already exist.
interface-type interface-number: Specifies a port to be configured as the reflector port by its type and
number.
Usage guidelines
You can configure reflector ports only for remote source groups but not for local mirroring groups or
remote destination groups.
Select a port not in use on the device to be configured as the reflector port. Do not connect a network
cable to the reflector port.
When a port is configured as a reflector port, all existing configuration of the port is cleared. You cannot
configure other features on the reflector port.
A Layer 2 aggregate interface or a tunnel interface cannot be configured as a reflector port.
Examples
# Create remote source group 1, and configure port Ten-GigabitEthernet 1/0/1 as its reflector port in
system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port ten-gigabitethernet 1/0/1
# Create remote source group 2, and configure port Ten-GigabitEthernet 1/0/2 as its reflector port in
interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] mirroring-group 2 reflector-port
Related commands
mirroring-group
mirroring-group remote-probe vlan
Use mirroring-group remote-probe vlan to specify a VLAN as the remote probe VLAN for a mirroring
group.
Use undo mirroring-group remote-probe vlan to remove a remote probe VLAN from a mirroring group.
Syntax
mirroring-group group-id remote-probe vlan vlan-id
undo mirroring-group group-id remote-probe vlan vlan-id