R21xx-HP FlexFabric 11900 Network Management and Monitoring Configuration Guide

111
• A port can serve as a source port for multiple mirroring groups, but cannot be a reflector port,
egress port, or monitor port at the same time.
• A Layer 2 aggregate interface cannot be configured as a source port for a mirroring group.
Configuration procedure
To configure source ports in system view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure source ports for the
specified local mirroring
group.
mirroring-group group-id
mirroring-port interface-list { both |
inbound | outbound }
By default, no source port is
configured for a local mirroring
group.
To configure source ports in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type N/A
3. Configure the port as a source
port for the specified local
mirroring group.
mirroring-group group-id
mirroring-port { both | inbound |
outbound }
By default, a port does not serve as
a source port for any local
mirroring group.
Configuring source CPUs for the local mirroring group
A mirroring group can contain multiple source CPUs.
To configure source CPUs for a local mirroring group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure source CPUs for the
specified local mirroring
group.
mirroring-group group-id
mirroring-cpu slot slot-number-list
{ both | inbound | outbound }
By default, no source CPU is
configured for a local mirroring
group.
Configuring the monitor port for the local mirroring group
You can configure the monitor port for a mirroring group in system view, or assign a port to a mirroring
group as the monitor port in interface view. The two modes have the same results.
Configuration restrictions and guidelines
• When a Layer 2 aggregate interface is configured as the monitor port, do not configure its member
interfaces as source ports.
• A mirroring group contains only one monitor port.