R21xx-HP FlexFabric 11900 Network Management and Monitoring Configuration Guide

115
Ste
p
Command Remarks
2. Create a remote destination
group.
mirroring-group group-id
remote-destination
By default, no remote destination
group exists on a device.
Configuring the monitor port for a remote destination group
You can configure the monitor port for a mirroring group in system view, or assign a port to a mirroring
group as the monitor port in interface view. The two modes have the same results.
When you configure the monitor port for a remote destination group, follow these guidelines:
• Do not enable the spanning tree feature on the monitor port.
• Use a monitor port only for port mirroring to make sure the data monitoring device receives and
analyzes only the mirrored traffic rather than a mix of mirrored traffic and normally forwarded
traffic.
• A mirroring group must contain only one monitor port.
To configure the monitor port for a remote destination group in system view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the monitor port for
the specified remote
destination group.
mirroring-group group-id
monitor-port interface-type
interface-number
By default, no monitor port is
configured for a remote destination
group.
To configure the monitor port for a remote destination group in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the port as the
monitor port for the specified
remote destination group.
mirroring-group group-id
monitor-port
By default, a port does not serve as
the monitor port for any remote
destination group.
Configuring the remote probe VLAN for a remote destination group
You must first create a static VLAN before you configure it as a remote probe VLAN.
When you configure the remote probe VLAN for a remote destination group, follow these guidelines:
• When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively.
• Configure the same remote probe VLAN for the remote destination groups on the source and
destination devices.
To configure the remote probe VLAN for a remote destination group: