R21xx-HP FlexFabric 11900 Network Management and Monitoring Configuration Guide

117
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure source ports for the
specified remote source
group.
mirroring-group group-id
mirroring-port interface-list { both |
inbound | outbound }
By default, no source port is
configured for a remote source
group.
To configure a source port for a remote source group in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the port as a source
port for the specified remote
source group.
mirroring-group group-id
mirroring-port { both | inbound |
outbound }
By default, a port does not serve as
a source port for any remote
source group.
Configuring source CPUs for a remote source group
A mirroring group can contain multiple source CPUs.
To configure source CPUs for a remote source group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure source CPUs for the
specified remote source
group.
mirroring-group group-id
mirroring-cpu slot slot-number-list
{ both | inbound | outbound }
By default, no source CPU is
configured for a remote source
group.
Configuring the egress port for a remote source group
You can configure the egress port for a mirroring group in system view, or assign a port to it as the egress
port in interface view. The two configuration modes lead to the same result.
When you configure the egress port for a remote source group, follow these guidelines:
• Disable these functions on the egress port: the spanning tree feature, IGMP snooping, static ARP,
and MAC address learning.
• A mirroring group contains only one egress port.
• A port of an existing mirroring group cannot be configured as an egress port.
To configure the egress port for a remote source group in system view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A