R21xx-HP FlexFabric 11900 Network Management and Monitoring Configuration Guide

85
The UDP echo operation requires both the NQA server and the NQA client. Before you perform a UDP
echo operation, configure a UDP listening service on the NQA server.
To configure the UDP echo operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is
created.
3. Specify the UDP echo type
and enter its view.
type udp-echo N/A
4. Specify the destination
address of UDP packets.
destination ip ip-address
By default, no destination IP
address is specified.
The destination address must be
the same as the IP address of the
listening service configured on the
NQA server.
5. Specify the destination port of
UDP packets.
destination port port-number
By default, no destination port
number is specified.
The destination port number must
be the same as that of the listening
service on the NQA server.
6. (Optional.) Specify the
payload size in each UDP
packet.
data-size size The default setting is 100 bytes.
7. (Optional.) Specify the string
to be filled in the payload of
each UDP packet.
data-fill string
The default setting is the
hexadecimal number
00010203040506070809.
8. (Optional.) Specify the source
port of UDP packets.
source port port-number
By default, no source port number
is specified.
9. (Optional.) Specify the source
IP address of UDP packets.
source ip ip-address
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, no UDP packets can be
sent out.
Configuring optional parameters for the NQA
operation
Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
To configure optional parameters for an NQA operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A