HP FlexFabric 11900 Switch Series OAA Command Reference Part number: 5998-4084 Software version: Release 2105 and later Document version: 6W100-20130515
Legal and notice information © Copyright 2013 Hewlett-Packard Development Company, L.P. No part of this documentation may be reproduced or transmitted in any form or by any means without prior written consent of Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.
Contents OAP manager commands ··········································································································································· 1 oap oap oap oap oap client close ························································································································································· 1 client reboot ········································································································································
OAP manager commands oap client close Use oap client close to shut down an OAP client. Syntax oap client close client-id Views System view Predefined user roles network-admin Parameters client-id: Specifies an OAP client by its ID in the range of 1 to 255. Usage guidelines When you execute this command for a client in registered state, the OAP manager sends a shutdown notification to the specified OAP client, and the client stops after receiving the notification.
Usage guidelines When you execute this command for a client in registered state, the OAP manager sends a restart notification to the specified OAP client, and the client restarts after receiving the notification. If you execute this command for a non-existent client, an error message appears. Client IDs are assigned by the OAP manager to OAP clients to uniquely identify the clients. Examples # Restart OAP client 1.
Views System view Predefined user roles network-admin Parameters minutes: Specifies the clock synchronization timer value in minutes, in the range of 0 to 1440. Setting this argument to 0 disables clock synchronization. Usage guidelines The clock synchronization timer regularly triggers the OAP manager to send clock and time zone synchronization notifications to OAP clients so the clients' clocks keep synchronized to the manager's clock. Examples # Set the clock synchronization timer to 20 minutes.
Support and other resources Contacting HP For worldwide technical support information, see the HP support website: http://www.hp.
Conventions This section describes the conventions used in this documentation set. Command conventions Convention Description Boldface Bold text represents commands and keywords that you enter literally as shown. Italic Italic text represents arguments that you replace with actual values. [] Square brackets enclose syntax choices (keywords or arguments) that are optional. { x | y | ... } Braces enclose a set of required syntax choices separated by vertical bars, from which you select one.
Network topology icons Represents a generic network device, such as a router, switch, or firewall. Represents a routing-capable device, such as a router or Layer 3 switch. Represents a generic switch, such as a Layer 2 or Layer 3 switch, or a router that supports Layer 2 forwarding and other Layer 2 features. Represents an access controller, a unified wired-WLAN module, or the switching engine on a unified wired-WLAN switch. Represents an access point.
Index DOSW oap timer clock-sync,2 D oap timer monitor,3 Documents,4 S O Subscription service,4 oap client close,1 oap client reboot,1 W oap enable,2 Websites,4 7
