R21xx-HP FlexFabric 11900 TRILL Configuration Guide

6
To enable TRILL:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enable TRILL globally
and enter TRILL view.
trill By default, TRILL is disabled globally.
3. Return to system view.
quit N/A
4. Enter Layer 2 Ethernet
or aggregate interface
view.
interface interface-type
interface-number
N/A
5. Enable TRILL on the
port.
trill enable By default, TRILL is disabled on a port.
Configuring the link type of a TRILL port
The following link types are available for a TRILL port:
• Access—An access port can process only local data frames and Hello frames.
• Hybrid—A hybrid port combines the attributes of an access port and a trunk port, and can process
local data frames and passing data frames.
• Trunk—A trunk port can process passing data frames and some of Layer 2 protocol frames (for
example, LLDP frames), but it cannot process local data frames.
To configure the link type of a TRILL port:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
or aggregate
interface view.
interface interface-type
interface-number
N/A
3. Configure the link
type of a TRILL port.
trill link-type { access | hybrid |
trunk }
By default, the link type of a TRILL port is
access.
Configuring the DRB priority of a TRILL port
On a broadcast network, TRILL must elect a DRB. An RB with a higher DRB priority is preferred. When two
RBs have the same DRB priority, the RB with a higher MAC address takes precedence.
To configure the DRB priority of a TRILL port:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet or
aggregate interface
view.
interface interface-type
interface-number
N/A