7500 20G Unified Wired-WLAN Module Basic Configuration Guide

# Create VLAN 8 through VLAN 10.

[AC]vlan 8 to 10

# Configure the link type of the Ten-GigabitEthernet1/0/1 interface of the switch as trunk and

assign the interface to aggregation group 1 (Ten-GigabitEthernet 1/0/1 is in aggregation group

1 by default).

[AC]interface Ten-gigabitethernet 1/0/1

[AC-Ten-GigabitEthernet1/0/1]port link-type trunk

[AC-Ten-GigabitEthernet1/0/1]port link-aggregation group 1

[AC-Ten-GigabitEthernet1/0/1]quit

# Bring up the Ten-GigabitEthernet1/0/2 interface of the switch, configure its link type as trunk,

and assign the interface to aggregation group 1 (Ten-GigabitEthernet 1/0/2 is in aggregation

group 1 by default).

[AC]interface Ten-gigabitethernet 1/0/2

[AC-Ten-GigabitEthernet1/0/2]undo shutdown

[AC-Ten-GigabitEthernet1/0/2]port link-type trunk

[AC-Ten-GigabitEthernet1/0/2]port link-aggregation group 1

[AC-Ten-GigabitEthernet1/0/2]quit

# Assign aggregate interface BAGG1 to VLANs 8 through 10.

[AC]interface Bridge-Aggregation 1

[AC-Ten-GigabitEthernet1/0/2]port link-type trunk

[AC-Ten-GigabitEthernet1/0/2]port trunk permit vlan 8 to 10

[AC-Ten-GigabitEthernet1/0/2]quit

3. Verify the configuration:

Packets from VLAN 1, and VLANs 8 through 10 are permitted to pass through the interfaces on the

switch and module.