HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

HA-Fabric Manager user guide 195
If there are no security settings being changed, the Security Change Confirmation and Status
dialog box is displayed with the Detailed Changes table showing that No Changes were
Found on the first row.
3. Click Start and the status window displays a message indicating the security settings are
identical and there are no changes to apply.
RADIUS Servers tab
The Radius Servers tab (Figure 118) allows you to specify the RADIUS server that will be used for
authentication.
Figure 118 Security Center Radius Servers tab
You can specify up to three RADIUS servers per switch. The device that must be authenticated by
the RADIUS server always is displayed at the top of the table. If the first device does not respond
after a certain amount of time due to connection or configuration problems, the next device is
authenticated, and so on.
The RADIUS servers and Sequence table includes information about the following:
• The Host Name can be an IP Address.
• The UDP Port displays the number that the device uses to contact the RADIUS server. The port
number is 1812 by default.
• The Time out(sec) displays the amount of time to wait for a response from the RADIUS server
before retransmitting the packet. It can be 1 to 1000; the default is 2 seconds.