BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
196
 Chapter 6: The Configuration Menu BMD00114, August 2009
Applying Pending Changes
To make your configuration changes active, you must apply them. To apply configuration changes,
enter apply at any prompt in the CLI.
Note – The apply command is a global command. Therefore, you can enter apply at any
prompt in the administrative interface.
Reverting Changes
The revert command removes configuration changes that have been made, but not applied.
Enter revert apply to remove all changes that have not been saved.
Saving the Configuration
In addition to applying the configuration changes, you can save them to flash memory on the
GbE2c.
Note – If you do not save the changes, they will be lost the next time the system is rebooted.
To save the new configuration, enter the following command at any CLI prompt:
When you save configuration changes, the changes are saved to the active configuration block. The
configuration being replaced by the save is first copied to the backup configuration block. If you do
not want the previous configuration block copied to the backup configuration block, enter the
following instead:
# apply
# revert
# save
# save n