BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
BMD00114, August 2009 Chapter 6: The Configuration Menu
 241
Temporarily Disabling a Port
To temporarily disable a port without changing its stored configuration attributes, enter the
following command at any prompt:
Because this configuration sets a temporary state for the port, you do not need to use apply or
save. The port state will revert to its original configuration when the switch is reset. See the
“Operations Menu” on page 379 for other operations-level commands.
/cfg/port <port number>/gig
Port Link Configuration Menu
Link menu options are described in the following table.
Main# /oper/port <port number>/dis
[Gigabit Link Menu]
speed - Set link speed
mode - Set full or half duplex mode
fctl - Set flow control
auto - Set autonegotiation
cur - Display current gig link configuration
Table 113 Port Link Configuration Menu Options (/cfg/port/gig)
Command Syntax and Usage
speed 10|100|1000|10000|any
Sets the link speed. Some options are not valid on all ports. The choices include:
 10 Mbps
 100 Mbps
 1000 Mbps
 10000 Mps
 any (auto negotiate port speed)
mode full|half|any
Sets the operating mode. Some options are not valid on all ports. The choices include:
 Full-duplex
 Half-duplex
 “Any,” for auto negotiation (default)