BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
288
 Chapter 6: The Configuration Menu BMD00114, August 2009
/cfg/l2/lldp
LLDP Configuration Menu
Use the following commands to configure Link Layer Detection Protocol (LLDP).
[LLDP configuration Menu]
port - LLDP Port Menu
msgtxint - Set transmission interval for LLDPDU
msgtxhld - Set holdtime multiplier for LLDP advertisement
notifint - Set minimum interval for successive trap notification
txdelay - Set delay interval between LLDP advertisements
redelay - Set reinitialization delay interval
on - Globally turn LLDP On
off - Globally turn LLDP Off
cur - Show current LLDP parameters
Table 149 LLDP Menu Options (/cfg/l2/lldp)
Command Syntax and Usage
port <port number>
Displays the LLDP Port Configuration menu. To view menu options, see page 290.
msgtxint <5-32768>
Configures the message transmission interval, in seconds. The default value is 30.
msgtxhld <2-10>
Configures the message hold time multiplier. The hold time is configured as a multiple of the
message transmission interval.
The default value is 4.
notifint <1-3600>
Configures the trap notification interval, in seconds. The default value is 5.
txdelay <1-8192>
Configures the transmission delay interval. The transmit delay timer represents the minimum
time permitted between successive LLDP transmissions on a port.
The default value is 2.
redelay <1-10>
Configures the re-initialization delay interval, in seconds. The re-initialization delay allows
the port LLDP information to stabilize before transmitting LLDP messages.
The default value is 2.