BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
28
 Chapter 2: First-Time Configuration BMD00114, August 2009
6. Enter the minute of the current time at the prompt:
Enter the minute as a number from 00 to 59. To keep the current minute, press <Enter>.
7. Enter the seconds of the current time at the prompt:
Enter the seconds as a number from 00 to 59. To keep the current second, press <Enter>. The
system then displays the date and time settings:
8. Enable or disable BOOTP at the prompt:
Enter d to disable BOOTP, or enter e to enable BOOTP.
9. Turn Spanning Tree Protocol on or off at the prompt:
Enter y to turn off Spanning Tree, or enter n to leave Spanning Tree on.
Setup Part 2: Port Configuration
When configuring port options for your switch, some prompts and options may be different.
Before you configure ports, you must decide whether you will configure VLANs and VLAN
tagging:
If you decide not to configure VLANs during this session, you can configure them later using the
configuration menus, or by restarting the Setup facility. For more information about configuring
VLANs, see your Application Guide.
Enter minutes [55]:
Enter seconds [37]:
System clock set to 8:55:36 Wed Jan 28, 2009.
BootP Option:
Current BOOTP: enabled
Enter new BOOTP [d/e]:
Spanning Tree:
Current Spanning Tree Group 1 setting: ON
Turn Spanning Tree Group 1 OFF? [y/n]
Port Config:
Will you configure VLANs and VLAN tagging for ports? [y/n]