BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
296
 Chapter 6: The Configuration Menu BMD00114, August 2009
/cfg/l2/lacp
LACP Configuration Menu
Use the following commands to configure Link Aggregation Control Protocol (LACP) for the
switch.
[LACP Menu]
port - LACP Port Menu
sysprio - Set LACP system priority
timeout - Set LACP system timeout scale for timing out partner
info
delete - Delete an LACP trunk
default - Restore default LACP system configuration
cur - Display current LACP configuration
Table 155 LACP Menu Options (/cfg/l2/lacp)
Command Syntax and Usage
port <port number>
Displays the LACP Port menu. To view menu options, see page 297.
sysprio <1-65535>
Defines the priority value (1 through 65535) for the switch. Lower numbers provide higher
priority. The default value is 32768.
timeout short|long
Defines the timeout period before invalidating LACP data from a remote partner. Choose
short (3 seconds) or long (90 seconds). The default value is long.
Note: It is recommended that you use a timeout value of long, to reduce LACPDU
processing. If your switch’s CPU utilization rate remains at 100% for periods of 90 seconds or
more, consider using static trunks instead of LACP.
delete <1-65535>
Deletes a selected LACP trunk, based on its admin key.
default sysprio|timeout
Restores the selected parameters to their default values.
cur
Display current LACP configuration.