BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
30
 Chapter 2: First-Time Configuration BMD00114, August 2009
6. The system prompts you to configure the next port:
When you are through configuring ports, press <Enter> without specifying any port. Otherwise,
repeat the steps in this section.
Setup Part 3: VLANs
If you chose to skip VLANs configuration back in Part 2, skip to “Setup Part 4: IP Configuration”
on page 31.
1. Select the VLAN to configure, or skip VLAN configuration at the prompt:
If you wish to change settings for individual VLANs, enter the number of the VLAN you wish to
configure. To skip VLAN configuration, press <Enter> without typing a VLAN number and go to
“Setup Part 4: IP Configuration” on page 31.
2. Enter the new VLAN name at the prompt:
Entering a new VLAN name is optional. To use the pending new VLAN name, press <Enter>.
3. Enter the VLAN port numbers:
Enter each port, by port number, and confirm placement of the port into this VLAN. When you are
finished adding ports to this VLAN, press <Enter> without specifying any port.
4. Configure Spanning Tree Group membership for the VLAN:
Enter port (1-24):
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
Current VLAN name: VLAN 2
Enter new VLAN name:
Define Ports in VLAN:
Current VLAN 2: empty
Enter ports one per line, NULL at end:
Spanning Tree Group membership:
Enter new STG index [1-128](802.1d)/[1](RSTP)/[0-32](MSTP):