BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
34
 Chapter 2: First-Time Configuration BMD00114, August 2009
3. Next, decide whether to apply the changes at the prompt:
Enter y to apply the changes, or n to continue without applying. Changes are normally applied.
4. At the prompt, decide whether to make the changes permanent:
Enter y to save the changes to flash. Enter n to continue without saving the changes. Changes are
normally saved at this point.
5. If you do not apply or save the changes, the system prompts whether to abort them:
Enter y to discard the changes. Enter n to return to the “Apply the changes?” prompt.
Note – After initial configuration is complete, it is recommended that you change the default
passwords as shown in “Setting Passwords” on page 35.
Optional Setup for Telnet Support
Note – This step is optional. Perform this procedure only if you are planning on connecting to the
switch through a remote Telnet connection.
1. Telnet is enabled by default. To change the setting, use the following command:
2. Apply and save the configuration(s).
Apply the changes? [y/n]
Save changes to flash? [y/n]
Abort all changes? [y/n]
>> # /cfg/sys/access/tnet
>> System# apply
>> System# save