BLADE OS™ Command Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 Command Reference
BMD00114, August 2009 Chapter 8: The Boot Options Menu
 391
Resetting the Switch
You can reset the switch to make your software image file and configuration block changes occur.
Note – Resetting the switch causes the Spanning Tree Group to restart. This process can be lengthy,
depending on the topology of your network.
To reset the switch, at the Boot Options# prompt, enter:
You are prompted to confirm your request.
Accessing the ISCLI
The default command-line interface for the switch is the BLADE OS CLI. To access the ISCLI,
enter the following command and reset the switch:
To access the BLADE OS CLI, enter the following command from the ISCLI and reload the switch:
Users can select the CLI mode upon login, if the /boot/prompt command is enabled. Only an
administrator can view and enable /boot/prompt. When /boot/prompt is enabled, the first
user to log in can select the CLI mode. Subsequent users must use the selected CLI mode, until all
users have logged out.
>> Boot Options# reset
Main# boot/mode iscli
Switch (config)# boot cli-mode bladeos-cli