BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
206
 Chapter 4: Configuration Commands BMD00115, August 2009
Management Network Configuration
These commands are used to define IP address ranges which are allowed to access the switch for
management purposes.
Table 106 Management Network Configuration Commands
Command Syntax and Usage
access management-network <IP address> <IP mask>
Adds a defined network through which switch access is allowed through Telnet, SNMP, RIP,
or the BLADE OS browser-based interface. A range of IP addresses is produced when used
with a network mask address. Specify an IP address and mask address in dotted-decimal
notation.
Note: If you configure the management network without including the switch interfaces, the
configuration causes the Firewall Load Balancing health checks to fail and creates a
“Network Down” state on the network.
Command mode: Global configuration
no access management-network <IP address> <IP mask>
Removes a defined network, which consists of a management network address and a
management network mask address.
Command mode: Global configuration
show access management-network
Displays the current management network configuration.
Command mode: All except User EXEC
clear access management-network
Removes all defined management networks.
Command mode: Global configuration