BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
BMD00115, August 2009 Chapter 4: Configuration Commands
 231
ACL Re-Mark Commands
You can choose to re-mark IP header data for the selected ACL. You can configure different
re-mark values, based on whether packets fall within the ACL Metering profile, or out of the ACL
Metering profile.
Re-Mark In-Profile Commands
Re-mark Update User Priority Commands
Table 125 Re-Mark In-Profile Commands
Command Syntax and Usage
access-control list <1-762> re-mark in-profile dscp <0-63>
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected value.
Command mode: Interface port
default access-control list <1-762> re-mark
Resets the update DSCP parameters to their default values.
Command mode: Interface port
show access-control list <1-762>
Displays the current ACL parameters.
Command mode: All except User EXEC
Table 126 Re-mark User Priority Command Options
Command Syntax and Usage
access-control list <1-762> re-mark dot1p <0-7>
Defines 802.1p value. The value is the priority bits information in the packet structure.
Command mode: Interface port
[no] access-control list <1-762> re-mark use-tos-precedence
Enable or disable mapping of TOS (Type of Service) priority to 802.1p priority for In-Profile
packets. When enabled, the TOS value is used to set the 802.1p value.
Command mode: Interface port