BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
250
 Chapter 4: Configuration Commands BMD00115, August 2009
spanning-tree mstp cist link-type {auto|p2p|shared}
Defines the type of link connected to the port, as follows:
auto: Configures the port to detect the link type, and automatically match its settings.
p2p: Configures the port for Point-To-Point protocol.
shared: Configures the port to connect to a shared medium (usually a hub).
The default link type is auto.
Command mode: Interface port
[no] spanning-tree mstp cist edge
Enables or disables this port as an edge port. An edge port is not connected to a bridge, and
can begin forwarding traffic as soon as the link is up. Configure server ports as edge ports
(enabled). The default value is disabled.
Note: After you configure the port as an edge port, you must disable the port
(interface port x shutdown) and then re-enable the port
(interface port x shutdown) for the change to take effect.
Command mode: Interface port
spanning-tree mstp cist enable
Enables MRST on the port.
Command mode: Interface port
no spanning-tree mstp cist enable
Disables MRST on the port.
Command mode: Interface port
show interface port <port number> spanning-tree mstp cist
Displays the current CIST port configuration.
Command mode: All Except User EXEC
Table 140 CIST Port Configuration Commands
Command Syntax and Usage