BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
258
 Chapter 4: Configuration Commands BMD00115, August 2009
LLDP Configuration
Use the following commands to configure Link Layer Detection Protocol (LLDP).
Table 147 LLDP commands
Command Syntax and Usage
lldp refresh-interval <5-32768>
Configures the message transmission interval, in seconds. The default value is 30.
Command mode: Global configuration
lldp holdtime-multiplier <2-10>
Configures the message hold time multiplier. The hold time is configured as a multiple of the
message transmission interval.
The default value is 4.
Command mode: Global configuration
lldp trap-notification-interval <1-3600>
Configures the trap notification interval, in seconds. The default value is 5.
Command mode: Global configuration
lldp transmission-delay <1-8192>
Configures the transmission delay interval. The transmit delay timer represents the minimum
time permitted between successive LLDP transmissions on a port.
The default value is 2.
Command mode: Global configuration
lldp reinit-delay <1-10>
Configures the re-initialization delay interval, in seconds. The re-initialization delay allows
the port LLDP information to stabilize before transmitting LLDP messages.
The default value is 2.
Command mode: Global configuration
lldp enable
Globally turns LLDP on. The default setting is on.
Command mode: Global configuration