BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
278
 Chapter 4: Configuration Commands BMD00115, August 2009
Protocol-Based VLAN Configuration
Use the following commands to configure Protocol-based VLAN for the selected VLAN.
Table 165 Protocol VLAN commands
Command Syntax and Usage
protocol-vlan <1-8> frame-type {ether2|llc|snap} <Ethernet type>
Configures the frame type and the Ethernet type for the selected protocol.
Ethernet type consists of a 4-digit (16 bit) hex code, such as 0080 (IPv4).
Command mode: VLAN
protocol-vlan <1-8> protocol <protocol type>
Selects a pre-defined protocol, as follows:
 decEther2: DEC Local Area Transport
 ipv4Ether2: Internet IP (IPv4)
 ipv6Ether2:IPv6
 ipx802.2: Novell IPX 802.2
 ipx802.3: Novell IPX 802.3
 ipxEther2: Novell IPX
 ipxSnap: Novell IPX SNAP
 netbios: NetBIOS 802.2
 rarpEther2: Reverse ARP
 sna802.2: SNA 802.2
 snaEther2: IBM SNA Service on Ethernet
 vinesEther2: Banyan VINES
 xnsEther2: XNS Compatibility
Command mode: VLAN
protocol-vlan <1-8> priority <0-7>
Configures the priority value for this PVLAN.
Command mode: VLAN
protocol-vlan <1-8> member <port number>
Adds a port to the selected PVLAN.
Command mode: VLAN