BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
BMD00115, August 2009 Chapter 4: Configuration Commands
 285
Note – If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.
Default Gateway Configuration
The switch can be configured with up to 4 IPv4 gateways. Gateways 1–4 are reserved for default
gateways. Gateway 4 is reserved for switch management.
This option is disabled by default.
no interface ip <interface number>
Removes this IP interface.
Command mode: Interface IP
show interface ip <interface number>
Displays the current interface settings.
Command mode: All
Table 169 Default Gateway Commands
Command Syntax and Usage
ip gateway <1-4> address <IP address>
Configures the IP address of the default IP gateway using dotted decimal notation.
Command mode: Global configuration
ip gateway <1-4> interval <0-60>
The switch pings the default gateway to verify that it’s up. This command sets the time
between health checks. The range is from 0 to 60 seconds. The default is 2 seconds.
Command mode: Global configuration
ip gateway <1-4> retry <1-120>
Sets the number of failed health check attempts required before declaring this default gateway
inoperative. The range is from 1 to 120 attempts. The default is 8 attempts.
Command mode: Global configuration
Table 168 IP Interface Configuration Commands
Command Syntax and Usage