BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
292
 Chapter 4: Configuration Commands BMD00115, August 2009
Route Map Configuration
Note – The map number (1-32) represents the routing map you wish to configure.
Routing maps control and modify routing information.
Table 175 Routing Map Configuration Commands
Command Syntax and Usage
route-map <1-32>
Enter route map configuration mode.
Command mode: Route map
[no] access-list <1-8>
Configures the Access List.
Command mode: Route map
For more information, see page 293.
[no] metric <1-16777214>
Sets the metric of the matched route.
Command mode: Route map
[no] metric-type {1|2}
Assigns the type of OSPF metric. The default is type 1.
 Type 1—External routes are calculated using both internal and external metrics.
 Type 2—External routes are calculated using only the external metrics. Type 1 routes
have more cost than Type 2.
 none—Removes the OSPF metric.
Command mode: Route map
precedence <1-255>
Sets the precedence of the route map. The smaller the value, the higher the precedence.
Default value is 10.
Command mode: Route map
enable
Enables the route map.
Command mode: Route map