BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
BMD00115, August 2009 Chapter 4: Configuration Commands
 295
Routing Information Protocol Interface Configuration
RIP Commands are used for configuring Routing Information Protocol parameters. This option is
turned off by default.
Note – Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
enable
Globally turns RIP on.
Command mode: Router RIP
no enable
Globally turns RIP off.
Command mode: Router RIP
show ip rip
Displays the current RIP configuration.
Command mode: All except User EXEC
Table 178 RIP Interface Commands
Command Syntax and Usage
ip rip version {1|2|both}
Configures the RIP version used by this interface. The default value is version 2.
Command mode: Interface IP
[no] ip rip supply
When enabled, the switch supplies routes to other routers. The default value is enabled.
Command mode: Interface IP
[no] ip rip listen
When enabled, the switch learns routes from other routers. The default value is enabled.
Command mode: Interface IP
Table 177 Routing Information Protocol Commands
Command Syntax and Usage