BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
296
 Chapter 4: Configuration Commands BMD00115, August 2009
[no] ip rip poison
When enabled, the switch uses split horizon with poisoned reverse. When disabled, the switch
uses only split horizon. The default value is disabled.
Command mode: Interface IP
[no] ip rip split-horizon
Enables or disables split horizon. The default value is enabled.
Command mode: Interface IP
[no] ip rip triggered
Enables or disables Triggered Updates. Triggered Updates are used to speed convergence.
When enabled, Triggered Updates force a router to send update messages immediately, even
if it is not yet time for the update message. The default value is enabled.
Command mode: Interface IP
[no] ip rip multicast-updates
Enables or disables multicast updates of the routing table (using address 224.0.0.9). The
default value is enabled.
Command mode: Interface IP
[no] ip rip default-action {listen|supply|both}
When enabled, the switch accepts RIP default routes from other routers, but gives them lower
priority than configured default gateways. When disabled, the switch rejects RIP default
routes. The default value is none.
Command mode: Interface IP
[no] ip rip metric [<1-15>]
Configures the route metric, which indicates the relative distance to the destination. The
default value is 1.
Command mode: Interface IP
[no] ip rip authentication type [<password>]
Configures the authentication type. The default is none.
Command mode: Interface IP
Table 178 RIP Interface Commands
Command Syntax and Usage