BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
BMD00115, August 2009 Chapter 6: Boot Options
 353
2. Enter the name or the IP address of the FTP or TFTP server:
3. Enter the name of the file into which the image will be uploaded on the FTP or TFTP server:
4. Enter your username and password for the server, if applicable.
5. The system then requests confirmation of what you have entered. To have the file uploaded, enter Y.
Selecting a Configuration Block
When you make configuration changes to the GbE2c, you must save the changes so that they are
retained beyond the next time the switch is reset. When you perform a save operation
(copy running-config startup-config
), your new configuration changes are placed in
the active configuration block. The previous configuration is copied into the backup configuration
block.
There is also a factory configuration block. This holds the default configuration set by the factory
when your GbE2c was manufactured. Under certain circumstances, it may be desirable to reset the
switch configuration to the default. This can be useful when a custom-configured GbE2c is moved
to a network environment where it will be re-configured for a different purpose.
In Global Configuration mode, use the following command to set which configuration block you
want the switch to load the next time it is reset:
Address or name of remote host: <IP address or hostname>
Destination file name: <filename>
User name: {<username>|<Enter>}
image2 currently contains Software Version 4.0.1
that was downloaded at 0:23:39 Thu Jan 1, 2009.
Upload will transfer image2 (2788535 bytes) to file "image1"
on FTP/TFTP server 1.90.90.95.
Confirm upload operation (y/n) ? y
Router (config)# boot configuration-block {active|backup|factory}