BLADE OS™ ISCLI Reference HP GbE2c L2/L3 Ethernet Blade Switch Version 5.1 Advanced Functionality Software

BLADE OS 5.1 ISCLI Reference
358
 Chapter 7: Maintenance Commands BMD00115, August 2009
Debugging Commands
The Miscellaneous Debug Commands display trace buffer information about events that can be
helpful in understanding switch operation. You can view the following information using the debug
commands:
 Events traced by the Management Processor (MP)
 Events traced to a buffer area when a reset occurs
If the switch resets for any reason, the MP trace buffer is saved into the snap trace buffer area. The
output from these commands can be interpreted by Technical Support personnel.
Table 220 Miscellaneous Debug Commands
Command Syntax and Usage
debug debug-flags
This command sets the flags that are used for debugging purposes.
Command mode: All except User EXEC
debug mp-trace
Displays the Management Processor trace buffer. Header information similar to the following
is shown:
MP trace buffer at 13:28:15 Fri May 25, 2001; mask: 0x2ffdf748
The buffer information is displayed after the header.
Command mode: All except User EXEC
debug mp-snap
Displays the Management Processor snap (or post-mortem) trace buffer. This buffer contains
information traced at the time that a reset occurred.
Command mode: All except User EXEC
clear flash-config
Deletes all flash configuration blocks.
Command mode: All except User EXEC