HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Application Guide

OSPF 124
e. Configure the OSPF Interface 2, and attach it to the stub area 1.
f. Click Submit.
6. Apply, verify, and save the configuration.
Example 2: Virtual links
In the example shown in the following figure, area 2 is not physically connected to the backbone as is usually
required. Instead, area 2 will be connected to the backbone via a virtual link through area 1. The virtual link must be
configured at each endpoint.
Figure 22 Configuring a virtual link
Configuring OSPF for a virtual link on Switch A
1. Configure IP interfaces on each network that will be attached to the switch.