ATM Configuration and Troubleshooting Guide

Conﬁguring EMS High Availability over ATM

Conﬁguring EMS HA-ATM for Local Recovery

Chapter 6122

• If a local recovery occurs to a secondary ELAN interface, and the

system reboots at a later time, if the primary ELAN interface is still

not operational, EMS HA-ATM will not provide local recovery to the

secondary ELAN interfaces. This is due to the information described

in the previous bullet (above). At this time, follow all steps described

in the previous bullet.

You can then go to one of these two sections:

• The next section, “Conﬁguring the Local Recovery Delay Period”, if

you need to conﬁgure a delay period for local recovery.

• “Starting the Monitor for the ELAN Interface Resource” on page 124,

if you do not need to conﬁgure a delay period for local recovery.