ATM Configuration and Troubleshooting Guide

Conﬁguring EMS High Availability over ATM

Conﬁguring EMS HA-ATM for Local Recovery

Chapter 6124

Starting the Monitor for the ELAN Interface Resource

NOTE If you will also be using EMS HA-ATM for remote recovery (with

MC/ServiceGuard), you do not need to do this task; MC/ServiceGuard

will perform the monitoring request.

To start the EMS HA-ATM monitor for the ELAN interface resource in

SAM, follow these steps:

Step 1. Log in as root.

Step 2. Type sam to start SAM.

Step 3. Select “Resource Management”.

Step 4. Select “Event Monitoring Service”.

This opens the “Event Monitoring Service” window, which lists all

resource monitoring requests on the system.

Step 5. Select Add Monitoring Request from the “Actions” menu.

This opens the “Add Monitoring Request” window. This window shows

the top-level classes for all of the installed monitors.

Step 6. Step through the hierarchy of classes until you get to the appropriate

class level. To do this, in the “Resource classes” list, select the following

items, in this order:

a. net

b. interfaces

c. switched

d. atm

Step 7. Select the resource (ELAN interface name) you want to monitor, in the

“Resource Instance” window.

Step 8. Select the OK button.

This opens the “Monitoring Request Parameters” window.

Step 9. Select the OK button to accept the defaults.