ATM Configuration and Troubleshooting Guide

Conﬁguring EMS High Availability over ATM

Conﬁguring EMS HA-ATM for Local Recovery

Chapter 6126

atm3 9360 none none 0 0 0 0 0

ipd0* 9180 none none 0 0 0 0 0

atm1 9360 none none 0 0 0 0 0

ipb0* 9180 none none 0 0 0 0 0

atm2 9360 none none 0 0 0 0 0

ipc0* 9180 none none 0 0 0 0 0

ela0 1500 200.128.168 200.128.169.5 3780 0 3472 78 0

ela1 1500 201.128.168 201.128.169.5 3595 0 3291 78 0

ela2 1500 202.128.168 202.128.169.5 3440 0 3133 79 0

elc0 1500 none none 12 0 0 0 0

elc1 1500 none none 12 0 0 0 0

elc2 1500 none none 12 0 0 0 0

elb0 1500 210.128.168 210.128.169.5 3529 0 3289 79 0

elb1 1500 211.128.168 211.128.169.5 3256 0 3025 79 0

elb2 1500 212.128.168 212.128.169.5 3256 0 3027 79 0

eld0 1500 none none 12 0 0 0 0

eld1 1500 none none 12 0 0 0 0

eld2 1500 none none 12 0 0 0 0

Step 13. Ensure that every conﬁgured primary ELAN interface has a

corresponding secondary ELAN interface. Each primary ELAN interface

must have a valid IP address, and each secondary ELAN interface IP

address must be listed as “none”.

CAUTION While the hatmmon daemon is running, do not use SAM or any of the

ATM conﬁguration commands to change the conﬁguration for an ATM

adapter that has any ELAN interfaces being monitored by EMS

HA-ATM. See “Modifying ATM Parameters when Using EMS HA-ATM”

on page 136.