ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Summary
Chapter 7144
Note that card_inst_num is the card instance number; for example, 0, 1,
2....
Getting Information about ATM Network Interfaces
To get information about ATM network interfaces, you can use the
commands shown in Table 7-2 below.
Display the Classical IP
ARP table
atmmgr card_inst_num show -i
Display SVC traffic
profiles for an ATM
adapter
atmconfig show -c card_inst_num
Table 7-1 Commands for Getting ATM Adapter Information (Continued)
To do this: Use this command:
Table 7-2 Commands for Getting ATM Network Interface Information
To do this: Use this command:
Display SVC traffic profiles for a
network interface
atmconfig show -n net_interface
Display all current and backup
LEC configuration and status
information
elstat -n net_interface -v
Display all current and backup
LEC statistics
elstat -n net_interface -s
Display the multicast MAC
addresses registered on current
and backup LEC interfaces
elstat -n net_interface -m
Display the current LE ARP
cache table entries
elarp -n net_interface
Display the destination IP
address of a LEC-to-LEC VC
elarp -n net_interface
followed by arp -a