ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Summary
Chapter 7146
Getting MPOA Information
To get MPOA information, you can use the commands shown in Table 7-3
below.
Table 7-3 Commands for Getting MPOA Information
To do this: Use this command:
Display configuration
and status information
for an MPC
mpcstat -n net_interface -c
Display statistics for an
MPC
mpcstat -n net_interface -s
Display the Ingress
Cache, Egress Cache,
and MPS tables for an
MPC
mpcarp -n net_interface
Display the full
information about the
Ingress Cache, Egress
Cache, and MPS tables
for an MPC at a specific
IP address
mpcarp -n net_interface -i
IP_address