ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7 151
The output from the command is as follows, where EPtRf is the End
Point Reference, whose value is given as a decimal:
ATM/AAL vc information
Getting Statistics for the AAL Interface
Use the following command to check AAL interface statistics (a card
instance number of 0 is used):
atmmgr 0 show -a
The output from the command is as follows:
AAL5 statistics
CRC-32 errors in received SDUs : 0
SDUs lost due to reassembly timeout : 0
SDUs too big : 0
A low value for each category indicates that the AAL5 interface is
working correctly. Specifically, the output provides information about
Service Data Units (SDUs).
Getting Cell Statistics, Addresses, Used VCCs, and
UNI Version
Use the following command to check the ATM cell statistics, ATM
address, number of VCCs in use, and the version of UNI configured for
an ATM card (a card instance number of 0 is used):
atmmgr 0 show -c
The output from the command is as follows: