ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7154
VPI,VCI
--------------------------------------------------------------
-----------
25.128.169.200 Static - PVC
0,100
25.128.169.201 Dynamic - PVC
0,101
25.128.169.202 Dynamic < ATM Address on 40 characters > SVC
0,50
25.128.169.203 Dynamic < ATM Address on 40 characters > SVC
0,58
The information in the Classical IP ARP table can be used to verify that
the IP and ATM address of the destination are correct, and that the
destination system is reachable and its IP address can be successfully
resolved into an ATM address.
Getting an ATM Adapter’s SVC Traffic Profiles
Use the following command to display the SVC traffic parameters
already defined for all network interfaces for a specific ATM adapter (a
card instance number of 0 is used):
atmconfig show -c 0
The output from the command is as follows:
Destination ATM Address Traffic Peak Sust.
Burst Min. Init
Interface type:Source ATM selector Type Rate Rate
Tol. Rate Rate
------------------------------------------------------------------
-----------------
Native UBR 155.52 - -
- -
4700918100000000e014cbb701.0060b0590138.00 ABR 45.00 - -
0.0 15.0
Classical IP:0