ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7 155
Getting an ATM Network Interface’s SVC Traffic
Profiles
Use the following command to display the SVC traffic parameters for an
ATM network interface (the example given is for the network interface
el100):
atmconfig show -n el100
The output from the command is as follows:
SVC traffic parameters configurations for ATM adaptator 0
Destination ATM Address Traffic Peak Sust.
Burst Min. Init
Interface type:Source ATM selector Type Rate Rate
Tol. Rate Rate
------------------------------------------------------------------
-----------------
Native UBR 155.52 - -
- -
4700918100000000e014cbb701.0060b0590138.00 ABR 45.00 - -
0.0 15.0
Classical IP:0
Note: VBR is Variable Bit Rate, UBR is Unspecified Bit Rate.
CBR is Constant Bit Rate, ABR is Available Bit Rate.
Getting LAN Emulation Configuration Information
Use the following command to display the LAN Emulation configuration
and status for an ELAN interface:
elstat -n net_interface -v
where net_interface is a currently configured ELAN interface. For
example, for ELAN interface ela0, the command is elstat -n ela0 -v;
and for ELAN interface el100, the command is elstat -n el100 -v.
The output looks like this (note, this example is for a configuration that
includes LANE V2 and MPOA):
Primary LEC configuration and status information
ATM Address :
47000580ffe1000000f124121f.080009c6fca2.00
LLC multiplexed