ATM Configuration and Troubleshooting Guide

Getting Status Information with ATM Commands
Command Examples
Chapter 7 161
MPOA Routers (MPOA Servers) Table for LEC interface el100:
MPOA Routers (MPOA Servers) Table for Primary LEC:
MPS MAC
(MPS Router)
Address Router MPS Address
------------ ------------------------------------------
080900010203 47010203040506070809101112.010203040506.98
080900020304 47010203040506070809101112.010203040506.98
080901010101 47010203040506070809101112.010203040506.98
080900030405 47010203040506070809101112.010203040506.98
To display the full information about the Ingress Cache, Egress Cache,
and MPS tables entries for a specific IP address, use this command:
mpcarp -n net_interface -i IP_address
So, for example, if you want to see the full information about the Ingress
Cache, Egress Cache, and MPS tables entries for the MPC that is tied to
the network interface el100, with the IP address 192.234.118.67, you
would issue this command:
mpcarp -n el100 - i 192.234.118.67
The output could look like this:
MPC Ingress Cache Table for LEC interface el100:
MPC Ingress Cache Table for Primary LEC:
MPS MAC
(MPS Router)
Address IPV4 Address Egress MPC Address
------------ --------------- ------------------------------------------
080900010203 192.234.118.67 47010203040506070809101112.010203040506.99
Entry State : active
Egress Cache Tag : 0x1234567812345678
Service Category : 765
Holding Time : 20mn
Retries : 18
Time Until Next Resolution Request : 10s
Prefix Length : 100
Last NHRP CIE Code : 123
Signaling Error Code : 124