ATM Configuration and Troubleshooting Guide

Migrating from the J2803B or J2498A ATM Adapters
Checking for and Reconfiguring Unsupported Traffic Profiles
Chapter 8174
NOTE The ABR traffic type is supported on SVCs only if your ATM switch
supports UNI 4.0 and if you set the UNI version parameter to UNI 4.0 on
the ATM adapter (see “Configuring the ATM Card Parameters” on
page 20).
Step 3. For each network interface configured on the adapter, do one of the
following:
• Reconfigure traffic profile types in SAM, so that only supported
traffic profiles are configured (see “Using SAM” on page 73 or
“Modifying a PVC Using SAM” on page 82).
or
• Use the commands atmconfig delete and atmconfig add to
reconfigure traffic profiles (see the atmconfig man page).