ATM Configuration and Troubleshooting Guide

Troubleshooting
ATM Commands
Chapter 9180
ATM Commands
Table 9-1 below lists commands you can use when administering and
troubleshooting the ATM network. For details of the full command
syntax and command usage, see Chapter 7, “Getting Status Information
with ATM Commands,” on page 141, or the command’s man page.
Table 9-1 ATM Administration and Troubleshooting Commands
To do this: Use this command:
Manage ATM connectivity,
display ATM stack statistics and
status, display the CIP ARP
server table, and display VC
information
atmmgr
Manage the traffic profiles for
ATM SVC connectivity
atmconfig
Check that the ATM hardware is
operational
atmloop
Check end-to-end connectivity atmcheck
atmserver
Reset or initialize an ATM
adapter
atminit
Reset or initialize only a specific
network interface on an ATM
adapter
atminit_net
Stop an ATM adapter atmstop
Stop only a specific network
interface on an ATM adapter
atmstop_net
Display ATM LEC configuration,
status, and statistics
elstat
Display MAC-to-ATM address
mapping
elarp