ATM Configuration and Troubleshooting Guide

Troubleshooting
Stopping an ATM Adapter
Chapter 9188
Stopping an ATM Adapter
To stop an ATM adapter, use the command atmstop, as follows:
atmstop card_inst_num
where:
card_inst_num is the card instance number of the ATM adapter (this is
also called the logical unit number). You can use the command
ioscan -fCatm to display the logical unit numbers of all ATM adapters
in your network (see “Resetting an ATM Adapter” on page 185).
The command stops the ATM adapter gracefully, closing all PVCs and
SVCs. All connections running across the network are stopped.
You must be superuser to use the atmstop command.