ATM Configuration and Troubleshooting Guide

Troubleshooting
Checking the ATM Address Network Prefix
Chapter 9220
/etc/atm/atm_0/ipa0 and /etc/atm/atm_0/ela0 (HP-UX 10.20), or
/etc/atm/atm_0/cip100 and /etc/atm/atm_0/el100 (HP-UX
11.X)—by hand.
Figure 9-7 Flowchart for Checking a Manual Network Prefix
A Read the ATM address. Use this command:
atmmgr card_inst_num show -c
Ensure that the address of the ATM adapter is known and that it
matches the one configured.
B Enter valid network prefix. Use SAM to enter the network prefix.
Note that the first byte (one digit) must be non-zero.
C Check switch. Ensure that the switch port has been configured with
the same ATM address as the ATM adapter to which it is connected.
Start
OK?
OK?
Read the
ATM address
Enter valid
network prefix
Check the switch
Configure switch
ATM address OK
No
Yes
No
Yes
A
B
C