ATM Configuration and Troubleshooting Guide

Troubleshooting
Checking the ATM Address Network Prefix
Chapter 9 221
Checking a Dynamic Network Prefix (ILMI)
The flowchart for checking an ATM address dynamic network prefix is
shown in Figure 9-8 below. Each of the circled letters is described on the
pages after the flowchart.
The ATM adapter must be started before you use this flowchart (the
state can be checked by using this command:
atmmgr card_inst_num show -p
To see how the network prefix was specified, run SAM and look at the
appropriate SAM window. The prefix is dynamic if it is set to From
Network in SAM. You can also find this information by examining the
ATM adapter configuration file (for example, /etc/atm/atm_0/nic). Do
not edit this file or the network interface files—for example,