ATM Configuration and Troubleshooting Guide

Installing and Configuring the ATM Software
Installing the ATM Software
Chapter 2 15
Step 4. Run the swinstall program by using the following command:
/usr/sbin/swinstall
This opens the “Software Selection” window.
Step 5. Change the Source Host Name, if necessary, and then enter the mount
point of the drive in the Source Depot Path field. Select the OK button to
return to the “Software Selection” window.
The “Software Selection” window now contains a list of available
software to install.
Step 6. Highlight the ATM software.
Step 7. Choose Mark for Install from the “Actions” menu; this chooses the
highlighted software.
Step 8. From the “Actions” menu, pull down the “Install...” menu, and then
choose Install. This begins product installation and opens the “Install
Analysis” window.
Step 9. Click on the OK button in the “Install Analysis” window when the Status
field displays a “Ready” message.
Step 10. Click on the YES button in the “Confirmation” window to confirm that
you want to install the software.
swinstall loads the fileset, runs the control script for the filesets, and
builds the kernel. The Status field displays a "Ready" message when the
processing is completed. Select the Done button and then the “Note”
window opens.
Step 11. Click on the OK button in the “Note” window to reboot. The user interface
disappears and the system reboots.
Step 12. Upon startup, log in as root and view the /var/adm/sw/swagent.log
and /var/adm/sw/swinstall.log files to view any error or warning
messages that might have occurred during the installation.
Step 13. If any errors are reported during installation, determine and fix the
cause of the errors and reinstall the software.
If the errors persist, see “Before You Begin Troubleshooting” on page 178
for details about troubleshooting.